« previous next »
Pages: [1]   Go Down

Author Topic: .21 clutch question  (Read 1102 times)

0 Members and 1 Guest are viewing this topic.

Offline beddo

  • Member
  • **
  • Posts: 21
  • Karma: 1
.21 clutch question
« on: May 13, 2009, 07:44:05 AM »
Hey Guys, quick question,
Ive bought a spares or repair Nanda Swift 2 which is basically a runner other than the clutch and pull start being missing.
Are all 21 size cranks the same size i.e. will any 21 size clutch fit or doe I need to buy the Nanda specific one?
Same for the pull start, although I would prefer to swap that for a rotostart if possible.

Cheers,
Beds
Logged

Offline Laughing Potato

  • I do it, because I love it!
  • Administrator
  • Hero Member
  • *
  • Posts: 6545
  • Karma: 63
    • RcKingdom
Re: .21 clutch question
« Reply #1 on: May 14, 2009, 07:31:52 PM »
The clutches should all be the same size, so you should have no problem there. Not so simple with the pull start though, the hex can be different sizes on those.
Logged
Over 20,000 bearings in stock right now - Over 300 Complete model bearing sets in stock right now!
In store http://www.RCbearings.co.uk and on Ebay ID:- RCbearings





www.RCbearings.co.uk - www.stars.org.uk - www.perfectpass.co.uk

Offline beddo

  • Member
  • **
  • Posts: 21
  • Karma: 1
Re: .21 clutch question
« Reply #2 on: May 14, 2009, 08:27:29 PM »
OK Cool, thanks LP.

Ive picked up a Schuey Swift 2 for £45 off the bay, its apparently a runner but the clutch and pullstart are missing.
Ive found all the clutch bits on the Schuey site, and a pull start on eBay, but I'll wait until it arrives on Monday to see what else is needed.

Logged
Pages: [1]   Go Up
« previous next »